UPP1-PR Programmer

UPP1-PR InCircuit production programmer with MMC/SD FlashCard for single Chip Controller

UPP1-PR  PDI, TPI, JTAG and SPI modes

With AES encryption and remote control by wire

• programs all in-circuit programmable AVRs Tiny4..Mega256, XMega
• programs the whole SPI programmable AT89S51..53 8253 family
• programs the AT89LPxx family
• Supports the TI/ChipCon CC1110, CC2510 and CC2430 family

• Connection to the PC through an USB port
• Full speed USB2 connection
• All data and parameters are stored in an exchangeable microSD Flashcard
• No powersupply necessary. The unit is powered direct from the USB port of the PC.
• Adapts automatical to the targets voltage (1.7-5.5Volt ca. 30mA)
• Programmer can supply the target with a variable voltage 1.8 to 5.2volts, 30..300mA
• Easy and extensive software
• Software runs under WinXP, Vista (32/64), Windows7(32/64)and Windows8
  
• Small, light weight and handy unit 72x75x30mm
• Hexfiles are loaded from PC into the programmer and stored
• CPU type, fusebits etc are selected from the Host/PC.
• Checksum generation. External power supply included.
• Remote controlled high volume production programmer
• SPI, JTAG, TPI, PDI programming support
• 
  
• Accessories (not included)
  
• Option adaptor from Atmel 6pol SPI to Atmel 10pol program connection (not included)

• Option adaptor from E-LAB JTAG to Atmel JTAG program connection (not included)
• Option adaptor from UPP1 6pin to TI/ChipCon CC2430 evaluation board (not included)

0 Review(s)

Write a review